Emergi-lite HZM Series User Manual download pdf

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com

03/11 750.0299 Rev. C

1/2

HZM Series

This equipment is rated for Class 1, Division 2, Groups A, B, C and D

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not let power supply cords touch hot surfaces.

2. Do not mount near gas or electric heaters.

3. Use caution when handling batteries. Avoid possible shorting.

4. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

5. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

6. Caution: If optional Halogen cycle lamp(s), symbol (H—), are used in

this equipment, to avoid shattering: do not operate lamp in excess of

rated voltage, protect lamp against abrasion and scratches and

against liquids when lamp is operating, dispose of lamp with care.

7. Halogen cycle lamps operate at high temperatures. Do not store or

place flammable materials near lamp.

8. Do not use this equipment for other than intended use.

9. All servicing should be performed by qualified service personnel.

SAVE THESE INSTRUCTIONS

Installation Instructions

1. The unit is to be installed with wiring methods in accordance with the

requirements of NEC Article, 500 and 501.

2. Turn off AC power.

3. Route AC circuit wires to electrical box and leave 12” of wire length.

4. Remove four screw on door. Open door by lifting it away from hous-

ing.

5. Securely mount unit in place. Connect AC supply wiring to unit as fol-

lows (see fig. 2):

For 120 VAC operation — Black to 120 VAC, white to neutral. Insu-

late unused wire.

For 277 VAC operation — Orange to 277 VAC, white to neutral.

Insulate unused wire.

6. Extend DC wiring for remote fixtures (if required) to unit. Wiring must

comply with NEC articles 700, 720 and 501-4. Do not exceed rated

wattage of unit, integral and remote lampheads combined.

7. Connect two white lamp wires to black wires from circuit board with

wirenuts provided (see fig. 2). Note: lamp wires are not polarized.

Part List

1. Housing

2. Door

3. Screw (4)

Figure 2

White

120 Black

277 Orange

AC Input

Test

To DC lamps

Battery

Black

White

Black

White

switch

+ –

Figure 1

1 2

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com03/11 750.0299 Rev. C1/2HZM SeriesHZM SeriesThis equipment is r

Page 2 - Diagnostics

HZM Series2/2Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com03/11 750.0299 Rev. C8. When ready to energize AC,

Comments to this Manuals

No comments

Emergi-lite HZM Series User Manual

Browse online or download User Manual for Power suppliers Emergi-lite HZM Series. Emergi-Lite HZM Series User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Power suppliers Emergi-lite HZM Series