Emergi-lite Prestige Economizer Series - Slim Profile Surface User Manual download pdf

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com

07/09 750.1357 Rev. D

1/2

Prestige Economizer Series - Edge-Lit Led Exits

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always

be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not use outdoors.

2. Do not let power supply cords touch hot surfaces.

3. Do not mount near gas or electric heaters.

4. Use caution when handling batteries. Avoid possible shorting.

5. Equipment should be mounted in locations and at heights where it will

not readily be subjected to tampering by unauthorized personnel.

6. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

7. Do not use this equipment for other than intended use.

8. All servicing should be performed by qualified service personnel.

SAVE THESE INSTRUCTIONS

Installation Instructions

1. Turn off AC power.

2. Route AC unswitched circuit of rated voltage into junction box and

leave 6” of wire length.

3. Follow directions on the panel for chevron placement. (Note: for sin-

gle sided units with clear background place chevron on back of the

panel).

4. Unsnap cover (12) by using your fingers, lift the bottom of the cover

and remove (if the cover is to difficult to open gently pry the cover

using a flat head screw-driver at the point indicated in fig.1).

Wall Mount (See Figure 1)

a. Extend the AC supply leads with the extension wires supplied (fol-

low the electrical wiring in figure 4).

b. Feed the supplied wires through the center hole of the spider plate

then attach it to the junction box.

c. Feed the supplied wires through the center hole of the canopy

then attach it to the spider plate using the screws provided (6).

d. Remove the knock out towards the inside with a screwdriver. Feed

the supplied wires through the center hole and mount the housing

to the canopy with the screws provided (4).

Ceiling or End mount (See Figure 2 & 3)

a. For ceiling mount: remove plugs (see figure 2)

a. For end-mount: remove the knock outs on the end cap towards

the inside with a screwdriver (see figure 3).

b. Fasten the canopy to the housing using screws(4) and lock nuts

provided (9).

Figure 1

Pry here

Part List

1. Junction box (existing)

2. Spider Plate

3. Junction box screws (not

supplied)

4. Canopy screws - long(2)

5. Canopy

6. Canopy screws - short(2)

7. Housing

8. End cap screws

9. Lock Nuts

10. Panel holder plugs

11. Panel

12. Cover

1 2

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com07/09 750.1357 Rev. D1/2Prestige Economizer Series - Edge-Lit Led ExitsPrestig

Page 2 - Maintenance

Prestige Economizer Series - Edge-Lit Led Exits2/2Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com07/09 750.1357 Rev. Dc. Exte

Comments to this Manuals

No comments

Emergi-lite Prestige Economizer Series - Slim Profile Surface User Manual

Browse online or download User Manual for Power suppliers Emergi-lite Prestige Economizer Series - Slim Profile Surface . Emergi-Lite Prestige Economizer Series - Slim Profile Surface Mount User Manual [fr]

Summary of Contents

Comments to this Manuals

Related products and manuals for Power suppliers Emergi-lite Prestige Economizer Series - Slim Profile Surface