Emergi-lite X10 LED Series User Manual download pdf

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com

05/10 750.1273 Rev. D

1/2

X10 Steel Series - Self Powered LED Exits

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not use outdoors.

2. Do not let power supply cords touch hot surfaces.

3. Do not mount near gas or electric heaters.

4. Use caution when handling batteries. Avoid possible shorting.

5. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

6. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

7. Do not use this equipment for other than intended use.

8. All servicing should be performed by qualified service personnel.

SAVE THESE INSTRUCTIONS

Installation Instructions

1. Turn off AC power.

2. Route AC unswitched circuit of rated voltage into electrical box and

leave 6” of wire length.

3. Remove exit face. To open the sign, remove screws from the end cap

(See Fig. 1) and slide out the exit face and the fibreglass diffuser.

4. Remove the appropriate chevron(s) on the exit sign by supporting the

exit face either side of the chevron and knock out carefully with a

screwdriver from the rear (See Fig. 2).

Wall Mount

a. Knock out the proper hole pattern in the back plate to mount to

the standard junction box (including the large wire hole); place a

support on either side of the hole to be removed and knock out

with a screwdriver.

b. Feed AC supply leads through the center hole.

c. Mount the exit sign securely to the junction box using the junction

box screws (See Fig. 3).

Figure 1

Figure 2

Figure 3

Part List

1. Junction box (existing)

2. Spider Plate

3. Canopy

4. Housing

5. Kep Nuts (2)

6. LED Strip

7. Junction box screws (not

provided)

8. Screws #8-32 x 3/8” (2)

9. Screws #8-32 x 1-1/2” (2)

10. Exit face

11. Back Plate (or second exit

face)

12. Diffuser Panel

13. End Cap

14. End cap screws (2)

1 2

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com05/10 750.1273 Rev. D1/2X10 Steel Series - Self Powered LED ExitsX10 Steel Ser

Page 2 - Maintenance

X10 Steel Series - Self Powered LED Exits2/2Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com05/10 750.1273 Rev. DCanopy - Ceil

Comments to this Manuals

No comments

Emergi-lite X10 LED Series User Manual

Browse online or download User Manual for Power suppliers Emergi-lite X10 LED Series. Emergi-Lite X10 LED Series User Manual [fr]

Summary of Contents

Comments to this Manuals

Related products and manuals for Power suppliers Emergi-lite X10 LED Series